2 colors pad printing machine
4 colors pad printing
4 colors pad printing machine
5 colors pad printing machine
130 mm pad printing machine
160 mm pad printing machine
automotive
automotive pad printing
ball screws
brushless motors
caps pad printing
ceramic ring pad printing
Comec Italia
cosmetic pad printing
easy pad printing machine
electrical equipment pad printing
electronically controlled axes
electronic pad printing machine
glass pad printing
hermetic inkcup
hermetic inkcup pad printing
hermetic inkcup pad printing machine
hermetic inkcups
independent pads
independent pads pad printing machine
KE13
KP08
KP08 Comec Italia
lead nuts
micrometric adjustment inkcup groups
oven
pad printing
pad printing ink
pad printing machine for lines
photoexposure
photoexposure unit
photopolymer cliché
pieces drying
plastic pre treatment
rotary pad printing machine
RR device
slide system
tampography
tampo machines
XE30
Ink does not meet adhesion requirements
| Probable Cause | Possible Solution |
| Pad | |
| Too much silicone on surface | Clean new pads with alcohol before use |
| Cliché | |
| Etched too deep | Redo a deeper cliché |
| Ink | |
| Wrong type of ink | Use the suitable ink according to the technical data sheet |
| Probable need for two-component ink | Use two-component ink with hardener |
| Incorrect ratio of ink to hardener | Remix ink with correct ratio by weighing ink and hardener |
| Material | |
| Dirty surface | Pre-clean with alcohol |
| Other | |
| No/insufficient pretreatment | Check pretreatment procedure. If necessary, repeat it |
| Polymerization time not respected | Let the pieces stand for longer time before testing |
| No/insufficient after-treatment | Use heat tunnel and in some situations do the flame treatment |
